Looks great man, I wish mine turned out as clean!
Printable View
Looks great man, I wish mine turned out as clean!
lol thanks man. funny thing is I haven't cleaned it since the last RC trip.... white just always looks clean in pictures!
I've been asked for these measurements so I'd figure i'd post them here.
Measured from center of hub up to bottom of fender flare:
Front (both sides) = 22"
Rear left = 22.5"
Rear right = 23"
Lift = OME HD + 1/4" strut spacers + F150 Load leveler shocks + custom 1/2" rear spring spacers
Notes = Full tank of gas, full line of skids/armor.
Not at all. I actually went back and measured again just to be sure.
playing around.... what do you guys think?? (maybe swap the red for blue!)
https://theultimatejeep.com/images/i...ttrg_001-1.jpg
https://theultimatejeep.com/images/i...9/9zwzub-1.jpg
I like those wheels alot!!! Would like nice painted matte green on my XK!!
They come in 18x9 5.7" backspace which is a spec i've been eyeing up for the SL in the future. The 18" will mitigate the tie-rod issue and allow use of 5.7" backspace wheels, which makes 9" wide OK. Though 18x8.5 with 5.7" backspace would be ideal, i like these a lot.
Im half tempted to try selling my current setup to throw these on (and get some cost effective AT's to run until the SL goes on)
I actually like your current wheels more then the motos :P
want to buy em?