Total cost $175!
Printable View
Total cost $175!
Looking great
Antenna relocated to driver's side....
https://theultimatejeep.com/images/i...IMAG0195-1.jpg
https://theultimatejeep.com/images/i...IMAG0197-1.jpg
Hey did you adjust your own rear axle? Just curious how hard was it to get it centered.
Yes I adjusted it myself. What I did was adjusted the new track back to the same length as the oem track bar. Then made a couple extra turns to make it a little longer. I installed it and the axle was still a little off to the drivers side. Probablly due to me just installing the OME HD Coils and getting more lift out of it. This past weekend after I relocated my antenna I crawled under the XK and re adjusted it to make it a little longer and now my axle is very close to being centered now. Its not hard to do, however I couldnt figure out a way to measure to get it exact. Close enough is a lot better then the axle way off to the drivers side. Once I fix the front end and take it in for an alignment ill see if they are able to get it dead on.
Ok I'll try it worse case I'll get a 4 wheel alignment.
New front drive shaft and all three bushings for the front differential are in. Looks like i'll be having fun tonight! That and ill fix the issue of the rear drive shaft hitting the gas tank skid plate.
https://theultimatejeep.com/images/i...2/03/105-1.jpg
https://theultimatejeep.com/images/i...2/03/106-1.jpg
https://theultimatejeep.com/images/i...2/03/107-1.jpg
https://theultimatejeep.com/images/i...2/03/108-1.jpg
https://theultimatejeep.com/images/i...2/03/109-1.jpg
https://theultimatejeep.com/images/i...2/03/116-1.jpg
https://theultimatejeep.com/images/i...2/03/117-1.jpg
UPS and FedEx visited me today!
Brand new Lower Control Arms and Jeepin by AL HD Upper Control Arms with Hummer H1 replacable ball joints!
https://theultimatejeep.com/images/i...IMAG0247-1.jpg
https://theultimatejeep.com/images/i...IMAG0248-1.jpg
Install is complete! I'll post pictures later. It goes in for an alignment tomorrow morning. Drives great!