I'm one step closer to finishing my intake mod. I've been searching for a pipe to use that could handle the heat as well and no one had one in my size. I looked at all the auto part stores and I just needed a pipe 5" long 3 1/2" wide. So was piecing things together and I picked up the stock cover that the tube plugs into and bang what dumb A** I am. I had the pipe the entire time I just needed to chop the one off the intake I pulled out so I did. I picked up a 1/2 male to a 1/2 serrated hose connection made out of brass. I drilled a 3/4" hole in the newly chopped off pipe and threaded the brass fitting in. The hole size was perfect and I actually had to use a wrench to thread it all the way in. Then I chopped the crank case hose the rubber one down to fit. So my crank case is back under vacuum. Now the thing is sitting on my second battery, so I'll address that issue at a later time.


Before

After