The only real pictures i have are the ones i already put up here. I bought a large enough piece of sheet metal. I cut it down to a size that was bigger than the area i needed to work on. I started bending and shaping it as i needed to get it to go where i needed it. I had to make almost a right angle cause i extended it under the jeep a little ways so i had to make 2 triangle cuts to get that to fit. I used self tapping sheet metal screws to screw it down in at both ends. When i finished it up it still rubbed a bit so i used a hammer to finish the shaping process and to get it to lay as close as possible to the lines. Then i painted it black. It still will rub every now and then when my wheel compresses but it aint going anywhere.