Looks great man, I wish mine turned out as clean!
Looks great man, I wish mine turned out as clean!
2007 Jeep Commander: QTII, Leather, Sunroof, remote start, OEM Skid Plates, 2 in Daystar lift, 255.75.17 BFG Mud Terrains on Moabs, 1.25 " Spidertrax wheel spacers, 4x Guard front guard and Side Guards, Optima Red Top, Robbys half inch leveling spacer, Bilstein 5150 Rear Shocks, Pinch weld mod and trimming!
lol thanks man. funny thing is I haven't cleaned it since the last RC trip.... white just always looks clean in pictures!
I've been asked for these measurements so I'd figure i'd post them here.
Measured from center of hub up to bottom of fender flare:
Front (both sides) = 22"
Rear left = 22.5"
Rear right = 23"
Lift = OME HD + 1/4" strut spacers + F150 Load leveler shocks + custom 1/2" rear spring spacers
Notes = Full tank of gas, full line of skids/armor.
Not at all. I actually went back and measured again just to be sure.
playing around.... what do you guys think?? (maybe swap the red for blue!)
I like those wheels alot!!! Would like nice painted matte green on my XK!!
2K6 Limited Jeep Green Metallic/Saddle Brown Leather XK HEMI QDII Old Man Emu HD Suspension w/ Fox Emulsion 2.0 Rear Shocks 1.5" SpiderTraxx Wheel Spacers 265/70 GoodYear MTRs w/Kevlar True Dual Exhuast w/IMCO 50 K&N 63 CAI Diablo 91/Performance Transmission Tuned SA Belly Skid MOPAR Gas Tank Skid, Transfer Case Skid, Suspension Skid Front Tow Hooks 6k HID Lows/3k Fogs
They come in 18x9 5.7" backspace which is a spec i've been eyeing up for the SL in the future. The 18" will mitigate the tie-rod issue and allow use of 5.7" backspace wheels, which makes 9" wide OK. Though 18x8.5 with 5.7" backspace would be ideal, i like these a lot.
Im half tempted to try selling my current setup to throw these on (and get some cost effective AT's to run until the SL goes on)
I actually like your current wheels more then the motos :P
There are currently 2 users browsing this thread. (0 members and 2 guests)