View Full Version : "Modified" Rusty's 2" lift
Holiday Jones
11-18-2015, 08:25 PM
I just bought Rusty's 2" springs front/rear, and I want to run the 5100@3/4" up front, and maybe leave the RC 2" spacer in the rear along with the new spring, and use f150 MLL.
Any thoughts?
Sent from my iPhone using Tapatalk
Holiday Jones
11-22-2015, 08:58 AM
alright
Sal-XK
11-22-2015, 01:06 PM
That might be a bit to much in the front. I would start at the lowest setting and go from their. Also the rear height would put the MLL out of spec.
Sent from my iPad using Tapatalk
Holiday Jones
11-22-2015, 02:18 PM
Yeah, I'm using 5125 bilstein s instead
Sent from my iPhone using Tapatalk
Sal-XK
11-22-2015, 03:12 PM
Keep in mind that the MLL where for just a two inch lift. So any higher then that and it'll be the same as stock shocks on a two inch lift.
Sent from my iPad using Tapatalk
Holiday Jones
11-22-2015, 04:37 PM
Keep in mind that the MLL where for just a two inch lift. So any higher then that and it'll be the same as stock shocks on a two inch lift.
Sent from my iPad using Tapatalk
^^
Sent from my iPhone using Tapatalk
Holiday Jones
11-22-2015, 04:37 PM
Using 5100 up front and 5125 out back
Sent from my iPhone using Tapatalk
Holiday Jones
01-28-2016, 07:40 AM
2612 Behold, the Modified Rusty's Lift
Sent from my iPhone using Tapatalk
JustinS
09-12-2016, 07:11 AM
I like it. I used a RR spacer and bilsteins set at .75 in my old commander
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.