Will the CB fit with the Adjustable pedal button

[XK N00b]

That's awesome, Sal! Let us know how the install goes. I just ordered the belly guard, and my front suspension skid should be here Friday. I had also thrown some tape up on the front bumper for the chop but, I haven't had the nerve to cut into it yet. I notice in your pics you've got the CB in the drivers cubby along with a switch, any idea if that would work with the factory adjustable pedal switch there?

[Sal-XK]

That's awesome, Sal! Let us know how the install goes. I just ordered the belly guard, and my front suspension skid should be here Friday. I had also thrown some tape up on the front bumper for the chop but, I haven't had the nerve to cut into it yet. I notice in your pics you've got the CB in the drivers cubby along with a switch, any idea if that would work with the factory adjustable pedal switch there?

Thanks bro, not sure about the CB I don't have the adjustable pedals so I can't comment on it. My bumper was scratched up from wheeling anyway so cutting it up didn't bother me. You just have to make that first cut then theres no going back LOL. I did a right up on the install you can find here Fuel Tank Install (http://www.xk-forum.com/showthread.php/727-Fuel-Tank-Skid-Install)

[hoaxci5]

I notice in your pics you've got the CB in the drivers cubby along with a switch, any idea if that would work with the factory adjustable pedal switch there?

Did the move the switch in 08's? Mine is 07 and the pedal adjust is down with the heated seats so I have my CB installed in the same spot as Sal.

[XK N00b]

Yeah, they must have, mine is an '08 and the switch is on the right side of that cubby

[Sal-XK]

post a picture of it. but I'm sure the Midland CB will fit.

[XK N00b]

https://theultimatejeep.com/notfound.png
my mistake, Left side of the cubby

[Sal-XK]

4.5 x 1.75 thats all you need to fit the midland in there. Looks like you have room just measure it you might have to trim a little bit. http://www.midlandradio.com/CB-Radio.WYQ/1001z

[Sal-XK]

You'll have to let us know what the measurements are on that cubby now I'm curious.

[cico7]

Looks like the right size to me too. .....slide one in and see.

[XK N00b]

https://theultimatejeep.com/notfound.png

https://theultimatejeep.com/notfound.png

I'm thinking, I'm going to need a slimmer CB

[Sal-XK]

Your good on the height but looks like your going to have to do some trimming to get the width to fit. You can approach this from a few different angles. You can relocate the switch or just trim to fit as is. Or you're going to have to find somewhere else for the CB or see if you can find a smaller CB. You can pull that plastic all out of that hole there and free up more room as well. Looks like your going to have to play around a little bit and see what you like.