Thats awesome. Ready to swap in that Rock Trac yet lol
Printable View
Thats awesome. Ready to swap in that Rock Trac yet lol
Im not sure what rock trac is, lol....
Yeah, this will be the biggest project I undertake - I'm having a VERY hard time deciding between a 4-6" lift or a XCASE swap to make this puppy laugh all the way to the top of the hill. I'll have to consult my Sensai - haha! :) Both will probably cost about the same 3-4k
TC first! Then the lift :)
I noticed after my first drive with the new shocks a 'clunking' which I kinda knew what it would be but I wanted to see what it would do. I don't know if the XK's have this problem. But some of the wheel well plastic gets awfully close to the shocks. Anyway, anytime I went down a dip, where the shocks have to respond quickly - The plastic would actually have noticeable contact with the coilovers. So I had to trim this down. I ran out of Daylight to tighty this one up, but I'll get to it tomorrow... Oh I will!
The Issue:
As you can clearly tell, plastic is too close. And yes, I can see that rubber boot slowly making it's way down the shock - I'll have to consult Sal with that one - because I'm not pulling that side shock off, lol. Was a PITA
https://theultimatejeep.com/images/i...0228_834-1.jpg
Solution!
Dremmel Tool, extension cord, power inverter
https://theultimatejeep.com/images/i...0135_658-1.jpg
https://theultimatejeep.com/images/i...0244_524-1.jpg
A minor set back:
So I've removed the majority of what I need but have not actually removed the piece yet. Well I let my hand down briefly, and tap the disk on the tire and it snaps in half. I kinda laughed because stuff like this happens to me all the time.
https://theultimatejeep.com/images/i...2518_853-1.jpg
But I was prepared!!!
https://theultimatejeep.com/images/i...2642_443-1.jpg
Nearly done
https://theultimatejeep.com/images/i...2722_336-1.jpg
As I said, I ran out of daylight, but I plan to tighten up the 'finish' so that it looks a little more professional.
I purchased the quick release system for my dremel look into it its pretty nice.
I vaguely remember your Dremmel tool - I'll have to check it out again when I come up there - hopefully SOON! :D
DUDE!!!! Those tires look awesome!!!! Man, I cant wait to go back to URE and see it perform! SO jealous of the jeep now.
And I have the same problem with that plastic. I just haven't purchased a dremel yet, lol.