<------ that dude, yeah... he's super jealous.
Printable View
<------ that dude, yeah... he's super jealous.
Just installed some new gears in the back of my friends 05 WK. Now just need to replace his steering rack and install his new front differential. His Jeep is going to be sick!
Did you actually get in the 3.73 gears or did you just go with the 3.55?
Installed Motive Gear 3.73's in the rear end. The back lash ended up perfect and the install went very smooth. Got a front differential out of a 05 4.7 Liter WK with 75,000 miles on it. His jeep has 80,000 so it worked out perfect. Installed new axle seals, pinion seal and new bushings in the differential cause they were all shot. The steering rack he ordered will be in today so everything should be done tonight hopefully. In the next few weeks/months QT II will be replacing the QT I and JBA headers will get installed. He has a 4 inch BDS lift w/AEV Module (Rustys rear LCA's/BDS rear UCA's) running 33x12.5R18 Toyo MT's. He also has a Flowmaster muffler and K&N CAI.
https://theultimatejeep.com/images/i...IMAG0239-1.jpg
https://theultimatejeep.com/images/i...IMAG0237-1.jpg
New 3.73's all set up and ready to go.
https://theultimatejeep.com/images/i...IMAG0241-1.jpg
wow.... I hope you keep track of all the required parts, lmao. Sal and I are intending on doing the same mod for my WK later this year. If you could eventually get it all into a 'HOW-TO' that would be killer. The more detail the better!
Sounds like that's going to be a killer Jeep!
Very cool. Can't wait to see that thing!
So you installed 3.73's on a QT1 jeep and no codes were thrown? Or did you just clear them out?
I have 3.73 gears in my garage waiting to be installed but am afraid of the codes.
Yeah the garage is a mess right now... but its easy to tell the new parts from old parts :D Do you want a "how to" for the gear swap or QT II swap?
Thats what were hoping. But unfortunately it still has a 3.7 liter. But between the CAI, Headers and 3.73 gears (along with the option of 4 low) he should be good to go.
Yeah 3.73's have been installed in the rear of a QT I jeep thats soon to be a QT II 3.7 liter. No codes as we arent totally done with the front end. Not worried about and issues with the computer/trans...we got that all figured out.
Correct. It should be done tonight though. It has however had the 4 inch BDS lift installed for the past 2 years with 33x12.5's. This picture was taken two summers ago after the lift was installed.
https://theultimatejeep.com/images/i...7001208a-1.jpg
This is the same WK that has the pinch weld modification done to it. It was pushed back approx. 2 inches
https://theultimatejeep.com/images/i...29001754-1.jpg