Understood.
It does not get that bad here so I can see why you would need it.
Printable View
Understood.
It does not get that bad here so I can see why you would need it.
It doesn't usually get in the negatives where I'm at (maybe the wind chill does) but it's not a bad thing to have one anyways. I paid $30 for the engine block heater from the dealer. It's just nice starting up you vehicle and having instant heat for those cold days! Especially when your windows are all iced up
My understanding of the no-slip is that it allows a wheel to freely spin faster than dictated by the driveshaft but not slower. This is different than a locker where both wheels move in lock step with the drive shaft and an open diff or limited slip where the load is balanced across the wheels and one may spin faster while the other spins slower than the driveshaft. This agrees with your statement that the no-slip drives the inner wheel around corners.
Have you experienced any adverse affects to date from the no-slip combined with the xk traction control...... e.i., what happens when the xk brakes one wheel on the axle, how does the no-slip react? Does this have any ill effects at the other end of the axle??????
I'm not sure if it allows a given tire to spin faster then the drive shaft? I didn't even know that is possible?!?
No adverse effects with the no-slip since it has been installed. It is literally transparent for daily driving. No traction control issue either. When off road, the traction control shouldnt brake one of the rear tires because there is never a time that one rear tire is moving faster then the other because the no-slip is at a full lock. Especially in 4 low with your foot on the gas. I've notice since the no slip has been installed the traction control really doesn't kick in at all due to the crazy amount of traction I'm now getting with the locker and aggressive mud tires
If you go around a corner with an open diff the outer wheel spins faster than the inner wheel as it has farther to go and the same amount of time to get there. When you do the same with a locker you get skipping and popping as one wheel has farther to go than the other but they are both forced to rotate in lock step.
In an open diff when a tire slips (ice under one tire for example) all power goes to the slipping tire and the other one just sits still. With a locker they both spin together and the one with traction keeps the vehicle moving forward.
A no slip attempts (and does a great job from what I hear) of giving the best of both worlds.... allowing one tire to spin faster than the other when cornering while not allowing all power to go to the faster moving (slipping wheel). it must either be allowing one tire to rotate faster than what's dictated by the driveshaft or slower. If it were slower, than the outside wheel would be the driving wheel around the corner.
Thanks for the great evaluation of it's behavior in our highly computer controlled xk's.
Made a final payment of $2000 on the Jeep on Tuesday with my tax return which cleared my bank today! Jeep is paid off (6 month early!!!) Next is new OME struts as mine are shot after two years of abuse lol. It will be getting new upper and lower isolators. I need to replace the passenger side cv shaft at the same time due to a ripped boot.
Congrats man, i bet it feels nice not having a car note
Oh it sure does! We shall see how long the Jeep lasts now. I have 127,000 miles on it.
dang put a few miles on it? mine is an 07 with about 65,000 to 70,000 haha