Yessir.
After I install a set to make sure everything good I'll let you guys know. I may have to chamfer the ID so they sit flush on the lower spring perch (which will require a trip down the street to my buddy's lathe)
Printable View
Sounds good
matt, if you make a set of 1/2" spacers for the rear i will def take a set!
That makes 9 sets.... ill probably order another sheet of material next week.
1) 2) Matt (2 sets for 1inch)
3) Corey-XK
4) 06JeepXKHEMI
5) 07JeepXK
6) stites-xk
7) pjmjr508
8) NoMatter
9) paroxysm
(Jon/Sal/adam.... not sure if this thread should stay here or be moved to the for-sale section?)
After the lift and tires my dog hesitates jumping in the back....now we'll see after these spacers/shocks Saturday lol
Are the spacers going to be the same top and bottom? I was thinking of going with a 1.5" spacer personally, but may be interested in this.
Whats the reason to go with spacers on both top and bottom rather then one spacer on one end?
The spacers will probably be the same exact design for top/bottom. I'll verify dimensions when I have Corey's apart this Saturday. Reason for going 1/2 top and 1/2 bottom is to ensure the spring is always captured and to facilitate installation. If I did 1" top, it would be a PITA to get the driver side spring back in. If I did 1" bottom, it would reduce the amount of remaining material that centers the spring/isolater.
Are the problems you are talking about issues with the current budget boost market?
No because they are either bolted in place (usually the uppers) or have their own self/centering features that center the spring isolaters.
The 5.25" hole-saw came in today and is the perfect diameter. The spacers are the same OD as the isolaters now. After work tomorrow I may take out my passenger side spring to see what type of ID & chamfer will work best.