Sal when you going to do the grill to match fenders and panels?
Printable View
Sal when you going to do the grill to match fenders and panels?
Yea just found it. Haven't gotten that far yet, lol.
Friday I put two new skid plates for ASFIR on my XK!
Last night my friend Jay replaced my crank seal. No more oil leak! Also found out my drivers side inner tie rod is shot. Ordered a MOOG inner tie rod last night which should be in today and hopefully installed tonight. Screw paying over $600 for a new steering rack.
Dropped off to get the windshield replaced along with some body damage from sliding off a road on ice. Nothing major. The 2nd day of our major snow here in WA (@ my house we got 22" of snow over a 3 day period, had a blast in it) I had a friend that was stuck in a ditch on a steep driveway. After getting him taken care of & on my way home I hit ice on a turn & hit a post on a corner. You can't tell any that I hit anything except that the parking & fog light do not work & I think the wheel sensor on that corner is out. I have been driving it for a week like that & its fine . Now that the snow is mostly gone I will get all fixed before it snows again the following week.
Along with that will have it detailed
Should have it back next week.
I replaced the drivers side inner and outer tie rods tonight. I feel bad for anyone that wasted anywhere from $600 to over a grand to replace their entire steering rack because they were told you cant get the inner tie rods separately. It took me about 45 minutes to do the install. I could have done it faster but wanted to make sure the new tie rods were the exact same length as the old so I can hold off on the alignment until I order the JBA UCA's. The steering is nice and tight again and no more clunking noises!
Nice. That's good info there^. Did you ever get around to doing the isolator? What a pain. Did mine last week.