Posted up already ^^^^
Printable View
Posted up already ^^^^
That link shows a longer sleeve not short ones like I have.. In the links picture its a single long piece that goes inside those bushings, I have 4 short sleeves that do not fit inside the bushings..
I know, lol we're posting too fast.
In my previous post I said you "should" have the longer sleeves that are 5/8" OD to convert the top shock mount to a bushing mount.
Those smaller metal spacers are for on each side of the bearing when using the heim setup.
So, after all the confusion hahaha how should I mount these bad boys up?!?!
Call JBA and ask them about the 5/8" OD - 1/2" ID sleeve that you believe you need to convert the top mount to a bushing mount. Then i'd install the bushings up top, use washer to fill any remaining gap, and use heim on the bottom.
How wide is the bottom with one of those metal spacers on each side?
Or just cut to the chase and order Part Number 9368T157 from mcmaster.com to save yourself the trouble.
1.25" the bottom measures with sleeve each side... Could I cut the top bushings down so they will fit up top and shim the bottom?
My problem is I have no idea how to change out the top mount, Im going to call JBA now and see how they suggest installing..