Those things look tough
Sent from my iPad using Tapatalk HD
Printable View
Those things look tough
Sent from my iPad using Tapatalk HD
This is something I found out about the Jeepinbyal control arms when runing the supperlift lift. I've been sending emails
Back and forth about my alignment problems I've been having since installation of the upper control arms.
The a-arms were desined for a lift kit other than Superlift, SL uses a
stering knuckle extention to level out the factory a-arm. *If you add more
lift to the jeep then our a-arms will work.
To make a long story short, my camber and caster cannot be adjusted anymore
to correct my toe out problem. Corrective action will be replace my inner outer tie rods from moog.. Just an fyi
Did they try adjusting the rear on the lower arm? When I had mine aligned they weren't sure they could get it withing spec. I told them the rear mount has at least an inch of adjustment to it, which they didn't know. After that the alignment was perfect! It was all basically maxed out, but within spec. However I don't have the JBA arms, I have the HM arms.
I just finished installing the JBA UCA's and new LCA's. I recently replaced my inner tie rods with MOOG and I'm only running a OME lift with stock steering knuckles so I should be good. It drives straight...no more clunking noises. It gets an alignment in the morning
Nice
Looks like I'll be trying the rocky road arms instead of JBA based of the measurements posted here:
http://www.jeepcommander.com/forums/...ad.php?t=17946
Hmmm. This has me thinking. I love my JBA UCA's and they were able to get the alignment dead on. The only thing I dont like is the clearance issue because I wheel the piss out of my XK. It seems like the JBA UCA's would work best for someone who only does normal street driving with a 2 inch lifted XK and wants a great set of UCA's that wont break and are totally rebuildable.
So now the question is, can you get the alignment dead on with the RRO UCA's like you can with the JBA's. As you know I just installed brand new meats on the XK and the last thing I want is for them to start cupping because I swap UCA's and they cant get the XK aligned to spec.
My alignment is currently "good".... its in the green but on the edge of the spec. It shouldn't take much to get it well within spec.
I have an inkling that the JBA arms are like that to get the alignment in spec on their 4" lift where the angles of the arms are really stretching the limits.
When I install my upper and new lower control arms.... in going to get the RRO and ream out the LCA slots to allow a little more adjustment.
I dont think you will need to ream them out. As it stands now with my JBA UCA's, the lower control arm bolts are in the exact middle of the slot. Meaning I still have adjustment both ways.