-
The 1.5" will be too much. My fenders are basically even right now, i just want to get the rear up a smidge higher for when the bumper goes on and 1/2" will be perfect.
Staying in the immediate area... just wanted to see if I could move up to a 4 bedroom while interest rates are low. I actually don't think my house will sell just because the market isn't that great yet.... but the realtor (a friends wife) did a market analysis and its not far from what i need, and she said I have a prime location plus its one of the nicest houses in the area that she's seen (i've done a lot of work).
-
Matt,
So are you going to be changing out that 1/2" spacer you made & replacing with a 1"?
I'm about to install my OME in a week or so & was going to copy how you set it up.
Also I looked at your garage & the lift install had a link to the back & that link is coming back as bad.
-
I actually planned on having two 1/2" spacers from the start.... one on the bottom and one on the top. I just never got around to making my top spacers...
Thanks for the heads up on the link; found it and fixed it.
-
Matt - what did you make the spacers out of? I may want to make one too.
-
I made them out of impact rated UHMW polyethylene.
-
Oh... how does one do that? (or... what is that stuff?)
-
lol. I usually order raw material through mcmaster.
Want to make sure you get something that'll survive outdoors + suspension loading. Can't just use any "plastic" because it you want good compression strength as well as chemical resistance from crap that'll get on it (particularly in winter).
-
K are you planning on making more? If so can I get another set to follow suit?
-
Hey PJ im sure I can take care of ya. Looks like theres 4-5 guys looking for a set now.
-
Ty. pm me details. i can pay for it on friday. payday
-
I'm not going to be able to make them that soon... this weekends shot, next weekends completely shot (Rausch Creek & midterm exam), so the soonest would be the following weekend.
However I'm planning on helping one of our supporting vendors get ramped up to make these, and possibly improve upon the design a bit (since they wont be hand made anymore). So hold tight and maybe that'll work out better instead of buying a set from me ;)
-
Understand about being busy. Sounds good to wait until the new version comes out, thanks for the information. Plus its not hard to just add them when they come in.