Replaced Front Driveshaft, and then booked it in to the stealership for all new front diff isolation bushes, apparently they are meant to have rubber in there??:eek:
Dave
Printable View
Replaced Front Driveshaft, and then booked it in to the stealership for all new front diff isolation bushes, apparently they are meant to have rubber in there??:eek:
Dave
I need to do mine. I need to call and ask how much. Im sure they are no good. Were you able to see them from underneath?
Yeah with all the plates off you can see them. Little mirror Helps. Unfortunately only 1 i think is a bolt on, the others are press in, so its a diff out scenario.
Dave
I need to do my diff bushings as well. From what I understand you can do them without pulling the diff out. Just removing the driveshaft and letting the diff hang. When I finally do it I'll report back.
In keeping with the thread: I threw a Rola Rack on today that I picked up used.
http://www.theultimatejeep.com/attac...0&d=1317347344
Nice rack :)
Rack looks good. Where is your bull bar mounted? Tow hook mounts? I've been looking at different options for the front end. Just don't know how it would look on mine because its not lifted. I don't like it when the bar hangs way low.
lol. Thanks.
No, it's not mounted to the tow hook points but, you can't have the bull bar and the tow hooks. And with the hardware that it came with it hung way low (slightly below the plastic air dam.) I had to cut most of the old mounting brackets off to get it where it is now. But as soon as I can get my hands on some .25" steel I plan on making a front receiver similar to the 4xGuard model with mounting points for the bull bar that will raise it up a little more and allow me to remove that little skid to expose a shackle in the receiver for recovery.
Reconnected my disconnects that have been off since .... not sure
I haven't been able to say this in a while without my wife hitting me, but Nice Rack!!!