Printable View
Hello, I have a lead on some nice rims. They have the following specs:
Size: 17x9 , Bolt pattern 5x5 , Offsett 4.5
How would this fit on an XK, I'm considdering using them for 285/70/17 with 2" lift and use my AEV Pintlers in the winter time.
Will they be a better or worse fit than my AEV WK pintlers in regards of rubbing ? How much more will the tire stick out ?
The pintlers have the following specs:
Size: 17" x 8.5" , Bolt Pattern: 5x5 , Offset 5,75"
Thanks in advance for any advice !
They'll stick out 1.75" further....not including the increase in tread width. Not going to fit those on your 2" lift without literally cutting out the pinch weld area and welding in a new section further back.
You won't fit that tire size with only a 2 inch lift and those wheels. They are to wide and will stick out way to far. 285's on any wheel is going to rub on a 2 inch lift unless you do the bumper mod and cut out your pinch weld completely. Also you would have to look into doing the rear ac/heat delete like I did. I ran 285/70's prior to the 305/70's I have now
Thanks guys, I wont be buying them now :)
Are you still planning on running a 285/70? If so what are your plans to make them fit.
I have the ome hd, and have done pw and reforming wheel weel. Have order hoses for rear heat delete.