2nd fuel cell? what all is needed?

i have been researching this for awhile...

i have saw on another site where i guy was going to use a zj fuel cell. i was just wondering as to what all i would need to get doing this as well?

what i would like to do is find out if i would be able to cut out an area next to the where the fuel tank filler is? maybe mount a gauge next to it as well?

i would like to use an external pump so that i could just fill my primary tank as needed?

so what else do need to get before i get into this?

1. fuel cell
2. filler hose
3. jeep wrangler fuel housing ( the cap and housing that goes around it?)
4. do i need to do something about ventilation?
5. fuel gauge? how would i go about wiring this up to show how much is in the tank?

assuming that theres 2 hose opening on the cell? i was thinking of using one to fill it and the other to mount another hose to the pump to fill the primary tank.

would it be simple to add a gauge to this? getting a sending unit is what this would connect to?

im thinking i would like to make this my next project...

any help would greatly be appreciated....

thanks

Here is a thread from a member on the forum who has added a secondary fuel cell. This should help you out and might be a better route then what you had in mind. Click here. http://www.xk-forum.com/showthread.p...s-tank-install

You can buy aftermarket fuel cells with the fuel sensors already mounted inside and just put another fuel guage inside the xk somewhere. My 66 ford has a 20 gallon fuel cell underneath the bed with the sensors in it.

Did you get the answers that you were looking for from the posts on my auxillary fuel tank. If you still have questions either PM me or ask here.