My Commander's Communications Suite

I’m currently running a Cobra 75WXST CB , M/A Com 700/800 MHz , Yaesu FT-7900R multi band Ham , and a “portable” ( think cigarette lighter plug, integrated speaker and magnetic antenna mount) VHF radio . Trying to find a place to mount them all was not easy, as a lot of you already know.
There is a small place under the glove box that I was able to use for wiring on top of the panel and then under the panel mount a radio and amplifier. The CB antenna coax connector went just to the left of the glove box.


https://theultimatejeep.com/images/i...SCN04261-1.jpg






……......Almost done.......



https://theultimatejeep.com/images/i...SCN04331-1.jpg



https://theultimatejeep.com/images/i...SCN04341-1.jpg


…….The other side…



https://theultimatejeep.com/images/i...SCN04271-1.jpg


………My CB coax cable antenna hook up....


https://theultimatejeep.com/images/i...SCN04251-1.jpg




……....Buttoned up…....



As a passenger sitting in the seat, you cannot see the face of the amp and their feet do not get close to hitting them.



https://theultimatejeep.com/images/i...DSCN0435-1.jpg

…...........700/800 MHz glass mount antenna….....


https://theultimatejeep.com/images/i...DSCN0580-1.jpg

…....Magnetic mount VHF antenna, when needed….


https://theultimatejeep.com/images/i...DSCN0581-1.jpg


To see how I mounted my CB and Ham antennas, click link below to my Steel Armadillo Bumper Mods.


http://www.theultimatejeep.com/showt...r-and-my-Mod-s

Now I needed to find a place to mount my speakers. I had just picked up a pair of new MLS-100’s and would use my old M/A Com speaker. I decided to mount them on my “B” posts. Two would be on the driver’s side so I could hear them easier.. …Hugh ? What did you say ??? ( been around jet noise way to long !).
I installed the other one on the passenger side.

https://theultimatejeep.com/images/i...DSCN0502-1.jpg


I found a screw behind the small panel towards the top of the pillar.


https://theultimatejeep.com/images/i...SCN04991-1.jpg


https://theultimatejeep.com/images/i...DSCN0501-1.jpg


I used a magnetized screw driver and very carefully removed the screw ( I put a small piece of tape on them when I re-installed them). If it drops behind the panel, you end up pulling a lot more and leaning how other things are mounted that you really didn’t want to know or care about. Or so I’ve heard!! Ya..

I pulled the rubber trim off and gently pulled the plastic molding out. I marked my holes for the speaker mounts and used SS bolts and lock washers, to attach them.


https://theultimatejeep.com/images/i...DSCN0503-1.jpg


https://theultimatejeep.com/images/i...DSCN0504-1.jpg


https://theultimatejeep.com/images/i...DSCN0505-1.jpg


https://theultimatejeep.com/images/i...DSCN0506-1.jpg


I trimmed a few of the plastic “fins” on the inside of the panel to make it easier to route the speaker wire.


……..rubber trim piece reinstalled…

https://theultimatejeep.com/images/i...DSCN0507-1.jpg

I was happy that the speakers do not interfere with anyone entering or exiting the back seat. I don’t normally have anyone in the back as all my gear is behind the front seats, but it was nice to note.


https://theultimatejeep.com/images/i...DSCN0766-1.jpg



https://theultimatejeep.com/images/i...DSCN0765-1.jpg


…………The other side…….




https://theultimatejeep.com/images/i...DSCN0616-1.jpg



The mic’s where much easier to install !!



https://theultimatejeep.com/images/i...DSCN0582-1.jpg



I did find there is one disadvantage of having plenty of communications capability..


OK ….who said what ??? ….on what Radio?????


https://theultimatejeep.com/images/i...DSCN0758-1.jpg

WOW! You're ready to stomp a tornado a new mudhole, if you decide to take up storm-chasing in it!!! ;)

That's a heck of a set-up. Too much for me though, I already too many voices. :cool:

holy crap that is quite the set up - I would probably run someone over at a crosswalk if I had all that going on near the windshield.

Sweet though!

That is nice way to much going on but really nice set up

Quote:

---

Originally Posted by BonesWK

holy crap that is quite the set up - I would probably run someone over at a crosswalk if I had all that going on near the windshield.

Sweet though!

---

Its not quite that bad. Honest !!

If I'm on the road, the portable radios are clipped to a multi pocket bag ( shown below ) that is strapped to the passenger seat. The only iteams above the dash are my flexable reading light, wireless remote for my spot light, Ham remote head and a pressure indicator ( out of view ) for my OBA.



https://theultimatejeep.com/images/i...DSCN0659-1.jpg

Quote:

---

Originally Posted by 1USMC

https://theultimatejeep.com/images/i...DSCN0758-1.jpg

---

My '92 Dodge Ramcharger restoration project is "ON" again - I want the dash in IT, to look like this! :o