Yea omelet has done the OME kit with a front strut spacer and rear puck ti get 4" lift
Yea omelet has done the OME kit with a front strut spacer and rear puck ti get 4" lift
JBA
4XG
S4XC
I think the question was will the OME lift level out the XK. I believe it does can't say with certainty. I'm sure someone will know for sure and chime in on that.
I would agree with Sal - And it really depends on what degree of a stickler you are when you say 'level'. I'd consider post OME lift hub center to fender F/R (22/21.5) to be fairly level. Although mine is probably closer to 22 now that all my crap is out. It would really depend on what you get, whether MD or HD.
As an FYI to better assist your coil selection
For 4.7L 4x4 XK Curb Weight: 4968 lb - weight distribution ratio (Front to Rear) 44/56 - Weight on the front axle: 2186 lb - on the rear axle: 2782 lb
The 4.7L V8 weighs approximately 437 lbs - and It doesn't weigh much less than a Hemi so this would generally apply to both. The Weight ratio difference for XK's F/R is even greater with the 3.7's. If you plan to get OME... And want to level it - I'd probably do the reverse of what WK's do and go MD front, HD rear - if you want to try to level it.
Hi,
Tanks for the OME spring & strut update. I will probably now for the first install the 1,5" level kit I already got.
Then next step, OME spring set with or without the 1,5" leveling kit. But like to know if I can install the OME springs with the 1,5" leveling kit?
Thx
Petter
Petter aka CJ-7
GPW 1943
CJ-7 AMC 360, 35" ARB f&b.
XK Commander LTD
The Jeep Garage:http://www.jeepclubnorway.no/smf/ind...opic,77.0.html
You will need to cut the front strut spacer
I am installing Robbys spacer next week and I have the Daystar lift. I only got the 1/2 inch spacer though and don't forsee any problems.
2007 Jeep Commander: QTII, Leather, Sunroof, remote start, OEM Skid Plates, 2 in Daystar lift, 255.75.17 BFG Mud Terrains on Moabs, 1.25 " Spidertrax wheel spacers, 4x Guard front guard and Side Guards, Optima Red Top, Robbys half inch leveling spacer, Bilstein 5150 Rear Shocks, Pinch weld mod and trimming!
Petter.......there is another member on the Commander forum that did a similar mod (my kit with a aftermarket spring)
He had installed the springs first and found that, although stiffer, the ride height had not changed.
I suspect the OME spring would have similar results.
You will have to search some......he posted before and after pics......was from Austrailia.
Holaday07 4.7.......your setup is a direct install............no surprises
Rob
There are currently 1 users browsing this thread. (0 members and 1 guests)