Front axle seal

[ScorpionCrawler]

I was wondering if anyone has replaced the front axle seal.
I was crawling around last night looking at the trans replace job and found a drip.
I don't remember it there before vacation.
Any input would be welcome.
I need to have the struts replaced again, which are both leaking and were replaced in July.
Dealer is warranting the part but not the labor so I may do the struts and the seal and maybe a lift all at the same time.
Anything else you think I should replace while I have it apart?

[/IMG]

[Holaday07 4.7]

Go ahead and getthe OME lift, and you will spend about the same if you install it yourself

[superacerc]

Go ahead and getthe OME lift, and you will spend about the same if you install it yourself

x2.
The OME is the way to go and you can permenantly disconnect the rear sway bar with the stiffer springs. They also help keep out sag as you add accessories.

[Sal-XK]

might as well hit the sway bar bushings while under there I guess. You can also do the diff isolater I think it's called I read a few members having to replace that.

[superacerc]

I've got to replace that on mine. I just looked under there yesterday and the rubber bushing on the isolater is tearing up pretty good.

[Sal-XK]

I've got to replace that on mine. I just looked under there yesterday and the rubber bushing on the isolater is tearing up pretty good.

Are you getting any clunking noise?

[ScorpionCrawler]

might as well hit the sway bar bushings while under there I guess. You can also do the diff isolater I think it's called I read a few members having to replace that.

Thanks for the input, I did the sway bar bushing in May and I'll take a look at the diff isolator this weekend.
I'll probably replace everything I can think of while I have it apart.
I'm thinking wheel bearings and maybe the half shafts as well depending on cost, I'm keeping this one forever and it's at 127,000 miles.