OME HD Install

[Matt]

holy crap these springs are STRONG!!!!!!!!!!!!!!!!!!





To anyone planning on doing this install.... DONT use a cheap spring compressor!! The unit I have goes for around $500 and it was a struggle!!

[EvilJager]

Get it installed already!

[Matt]

For anyone installing new struts, this trick works great. Flip the bolt around and put a washer in there. Then snug the bolt up to "separate" the fork. This not only makes it easier to take off, it makes it as simple as it gets to get the fork on the new strut.



You guys want to know a little secret to get an extra 1/4 of lift height? Well, the hole for the strut fork bolt is greatly oversized. So you want to make sure that when you install it, you have the fork as low as possible on the strut; increasing the overall length of the assembly.

[Matt]

With my RC kit + JBA Spacers:
Front left = 36-1/8
Front Right = 36-3/16
~21.5 From hub to fender

With my OME HD kit + JBA Spacers:
Front left = 36-1/2
Front Right = 36-7/8
~22" From hub to fender

Overall, i've gained 1/2" over my previous setup. Hopefully they don't settle too much, but right now it's EXACTLY where i wanted it

Angles:

[Matt]

This is what we've been waiting for!!!

Stock struts with RC kit have 1.75" LONGER extended length than OME struts. (This is about 3.5" more down travel than OME struts... but the UCA will hit the strut first at about 2" over stock.)

OME struts are about 3/8" LONGER (closer to 5/16) extended length than stock struts. (This is about .75" (max) more down travel than stock)





Also, as the one picture shows but it may not be obvious, the lower spring seat is also in the stock position....

I see absolutely no reason why someone couldn't use stock springs with OME struts as a strut-only upgrade if they want to retain stock height. This should FINALLY put all that to rest.

[hoaxci5]

But how to do you feel about OME springs with OEM struts?

[Matt]

i haven't driven it much..... for the driving i have done, they feel good. Not as stiff as i expected.

Honestly, i was expecting to feel more of a drastic difference. I'll see when i hit some of the old railroad tracks on my way to work.

[Sal-XK]

Some pretty useful tips bro thanks for sharing man..

[Matt]

Quick update... its been 2 weeks and the fronts haven't settled at all. Measured the same tonight as they did when i put them in.

Here's a link to the thread where I put the rear springs in:
http://www.theultimatejeep.com/showt...storming-ideas...