CB Antenna mount

**EvilJager** · 10-19-2011, 01:19 PM

Lol nope mine is one of a kind! Lol ill get a pic when i get it back! The one i made is all enclosed

**Budasac** · 10-19-2011, 01:27 PM

Originally Posted by EvilJager

Lol nope mine is one of a kind! Lol ill get a pic when i get it back! The one i made is all enclosed

Ohhh, so you copied the first mount I made. lol. Doesn't 4xguard have an enclosed one? I'm pretty sure that's where I got the idea for the first one.

**EvilJager** · 10-19-2011, 03:03 PM

Lol then its prob close to your first o e then cause thats where i got my idea from

**Budasac** · 10-19-2011, 06:41 PM

I debated boxing it in but that would have meant pulling out the welder, which typically isn't a chore but, I'm 90% done building a new shed and all my lawn crap is in the garage.

I just finished making up new ends on the antenna wire since I had to cut off the section that was pinched by the tail light. Too dark and rainy for pics though. I think it looks pretty good now that it's all finished. Just have to find someone local who can tune the antenna.

**EvilJager** · 10-19-2011, 06:56 PM

I understand completely lol... i boxed mine in and molded it to the body so it would look a little neater. But ill prob end up buging the 4xg one... i cant leave anything alone. Im always changing something on my jeep lol

**hoaxci5** · 10-19-2011, 07:49 PM

Looks good, I boxed mine in, but it basically because I was looking for a reason to use my welder

**Budasac** · 10-22-2011, 04:32 PM

Yeah, usually I'm just lookin for an excuse to weld, but it wasn't all that accessable so I went for the simple route. I'm happy. My biggest concern was strength and this thing is solid as can be.

I finally had a chance to take somer pics of the finished install: