Page 3 of 3 FirstFirst 123
Results 21 to 24 of 24

Thread: Replacement rear diff carrier?

  1. #21
    Lifetime Member Getting Dirty valpacer's Avatar
    Join Date
    Sep 2011
    Posts
    261
    Rep Power
    13
    Been searching, no luck yet. But if the TCS was still even partially operational in 4low this wouldnt be possible...



    Dave
    2007 WH Grand Cherokee CRD QDII - 3" Exhaust, GDE Flash Tune, CRDSTU Hybrid Lift & bash Plates, 4xGuard Rock Rails & Rear Sliders, Saguaro F&R Bars, Warn 9.5CTI-s, AEV Saverge Rims, 35" KM2's, Snorkel, Custom Rear Drawers, ARB Dual Compressor + On Board Air, BullyDog Monitor, Dual Optimas Front and Dual Rear Aux Batteries YouTube Vids

  2. #22
    Lifetime Member Getting Dirty Sal-XK's Avatar
    Join Date
    Jun 2010
    Location
    Raeford NC
    Posts
    5,201
    Rep Power
    20
    Don sent me some links I'll check them out when I get a chance. I'm pretty sure in 4LO QD2 it's all the elsd doing all the work no brakes or anything.

  3. #23
    Lifetime Member Getting Dirty Matt's Avatar
    Join Date
    Feb 2011
    Posts
    7,771
    Rep Power
    22
    I'm pretty sure you're right sal.... it wouldn't make sense to activate the brakes once the differentials are locked because that would thereby hinder both tires from rotating.

    Also, on Sunday I pulled my friends 6500# 28' boat out of the water using a half beach/half paved ramp and had all 4 of my tires spinning in 4 low.... at no time did I hear my ABS pump kick in to activate the brakes, and I didn't even press the button to turn off traction control.

  4. #24
    Lifetime Member Getting Dirty Sal-XK's Avatar
    Join Date
    Jun 2010
    Location
    Raeford NC
    Posts
    5,201
    Rep Power
    20
    With QT2 the brake torque is still activated for us or we would be just wheeling open open. As we hit the button were just basically telling the jeep how much wheel spin we need to get. At full off there is still a point where the system will kick in and try and stop the wheel from spinning on the QT2. QD2 I think the button has more to do with you guys in 4HI. Remember the QD2 system uses three things to fix wheel spin the brakes, engine power and clutch packs. As you change your setting you get a combination of these things QT2 obviously don't have the clutch packs.

Page 3 of 3 FirstFirst 123

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. rear tire carrier builds...
    By my4thjeep in forum Exterior Modification
    Replies: 1
    Last Post: 09-27-2011, 03:01 PM
  2. Rear diff leaking - pinion seal
    By jcoulter in forum Transmissions / Transfer Cases / Drive Train
    Replies: 12
    Last Post: 07-28-2011, 08:52 AM
  3. is this a rear diff Roller?diff protection?
    By ped4599 in forum General Jeep Commander & Grand Cherokee Discussion
    Replies: 8
    Last Post: 06-22-2011, 06:55 AM
  4. Jeep Commander Rear Diff disassembly Chrysler 8.25 29 spline 12 bolt QD2
    By Sal-XK in forum Transmissions / Transfer Cases / Drive Train
    Replies: 0
    Last Post: 03-25-2011, 06:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •