BAD WIRE FROM TPS SIGNAL WIRE TO ECM/PCM
An Implausible Data Configuration can be caused when the PCM / TCM / FCM are not talking to each other

the "U" codes are only a communication error and won't affect performance or pull timing.



U140E-IMPLAUSIBLE VEHICLE CONFIGURATION DATA RECEIVED

When Monitored: Continuously with the ignition on.
Set Condition: When the Anti-Lock Brake Module detects an incorrect CAN messages from the Engine Control Module (ECM).
Possible Causes
FCM CAN BUS DTCS
ENGINE DTCS
ANTI-LOCK BRAKE MODULE

this DTC is generated by the ABS control module and should not illuminate the engine MIL. it may, however, illuminate the ABS warning lamp. the ABS module does not recognize a message from the PCM. pretty sure your B&G PCM is causing this. not the first one i've read about.


Hope this helps........