How to Install the 4xG Matrix

[AJeepZJ]

Wallaaaaaa - After everything has been removed - This is how your WK should like (and how your XK might look). We are ready to begin installing stuffs.. yayyyy rawrrrrr!!


Pull these brackets out of the bag, get them ready... they are next!


Place these brackets LIKE SO... so that they fit... Just like a puzzle!! yeeaaahhhhh.

Passenger side


Driver side


Retreive your first piece of 4xG mounting parts and install! (Part numbers XG-K200.01 and XG-K200.02) Pictured BELOW!
It will be bolted to the mounting brackets you just placed inside the cross member. Use the nuts you PURCHASED, and hand tighten this part to the bracket. (4xG stresses that you do NOT fully tighten... so I stress you just hand tighten.)

Passenger Side - follow this procedure for both sides


Please pay close attention to how these backing plates are placed inside the cross member. There are two squares on each of these brackets.. you want the side of this bracket with the GREATEST distance between the squares facing OUTWARD. Match these up with the holes that go through the frame. Line everything up because we will be installing the inside mounting brackets next!


Get your inside mounting brackets - part numbers XG-K200.03 and XG-K200.04) using two 1.25” x 7/16” hex bolts and install them.. Place bolts in the holes and screw them in, with your other hand hold the inside back plate in place and also hold the nut over the hold while you twist the bolts in. Picture below! (In this picture I used the wrong screws - I did fix this, but don't make my mistake, I had to go back)

[AJeepZJ]

Remember those two black steel 'cups' with a single screw we removed from the cross member behind the bumper to place the OEM mounting brackets on? Go ahead and put those back on. and then it is ok to go ahead and Place the bumper back on the Jeep - You do not have to bolt and fasten it back onto the Jeep just yet - In fact, I would recommend you not do that. Just put the bumper back on.


You should have the outside brackets, backing plates, and inside brackets installed at this time. We are now moving on to the 4th item. The bow shackle brackets aka Part Numbers (XG-K221.05) on the outside of the mounting brackets we just installed. Start by aligning the rear most hole of the bow shackle bracket with the rear most hole in the mounting brackets. Use three 1.5” x 1/2” hex bolts with 1/2" lock flange nuts. Pictured below is how it will look.



Assemble the 4xGuard Center bracket with the two sides that go on it... Part numbers XG-K220.10 to the light tab brackets part number (XG-K221.07 and XG-K221.08) with the provided 3/4” x 3/8” hex bolts and 3/8” lock nuts. Do this over grass or in your lap to prevent scratches and stuff to the face of it (prevent rust).


bolt the bumper back on, reinstall the grill, reconnect your fog lights and BAM!!! Check for tighteness and allignment. Make sure everything is nice and tight. I never really truly specified when it was ok to go ahead and tighten everything. This is a step that can practically be done at the very end.