Remember those two black steel 'cups' with a single screw we removed from the cross member behind the bumper to place the OEM mounting brackets on? Go ahead and put those back on. and then it is ok to go ahead and Place the bumper back on the Jeep - You do not have to bolt and fasten it back onto the Jeep just yet - In fact, I would recommend you not do that. Just put the bumper back on.


You should have the outside brackets, backing plates, and inside brackets installed at this time. We are now moving on to the 4th item. The bow shackle brackets aka Part Numbers (XG-K221.05) on the outside of the mounting brackets we just installed. Start by aligning the rear most hole of the bow shackle bracket with the rear most hole in the mounting brackets. Use three 1.5” x 1/2” hex bolts with 1/2" lock flange nuts. Pictured below is how it will look.



Assemble the 4xGuard Center bracket with the two sides that go on it... Part numbers XG-K220.10 to the light tab brackets part number (XG-K221.07 and XG-K221.08) with the provided 3/4” x 3/8” hex bolts and 3/8” lock nuts. Do this over grass or in your lap to prevent scratches and stuff to the face of it (prevent rust).


bolt the bumper back on, reinstall the grill, reconnect your fog lights and BAM!!! Check for tighteness and allignment. Make sure everything is nice and tight. I never really truly specified when it was ok to go ahead and tighten everything. This is a step that can practically be done at the very end.