I'm going to sneak one of those on when my fluid is do for a change wife won't know the difference LOL
I'm going to sneak one of those on when my fluid is do for a change wife won't know the difference LOL
got all three of mine today!
2007 Jeep Commander: QTII, Leather, Sunroof, remote start, OEM Skid Plates, 2 in Daystar lift, 255.75.17 BFG Mud Terrains on Moabs, 1.25 " Spidertrax wheel spacers, 4x Guard front guard and Side Guards, Optima Red Top, Robbys half inch leveling spacer, Bilstein 5150 Rear Shocks, Pinch weld mod and trimming!
That sucks! Well at least you took one for the team I would of filled it up to.
Sent from my iPhone using Tapatalk
Yea this one is for the team.
Today's lesson brought to you by the letter "O" - Do not "O"ver fill your rear axle. It'll come out of the breather tube.
SOLD - 2005 | WK | Khaki | 3.7 | QT1 | OME HD Front Struts | Rusty's 2" lift in Rear w/ Monroe load levelers (F150 version) | 265/70 Nitto Terra Grapplers | 17" Moabs | 1.5" wheel spacers | Pinch weld mod | Rear fender trim mod | 4xG Matrix w/ reciever hitch | 4xG Belly guard | SOLID Diff cover | Cobra CB radio | 4xG CB radio antenna mount
The hand pump didn't work on taking the oil out. Tomorrow morning, I'm going back to Advance and get more fluid and rv sealant. I'll just start from scratch and n ot put too much fluid in.
SOLD - 2005 | WK | Khaki | 3.7 | QT1 | OME HD Front Struts | Rusty's 2" lift in Rear w/ Monroe load levelers (F150 version) | 265/70 Nitto Terra Grapplers | 17" Moabs | 1.5" wheel spacers | Pinch weld mod | Rear fender trim mod | 4xG Matrix w/ reciever hitch | 4xG Belly guard | SOLID Diff cover | Cobra CB radio | 4xG CB radio antenna mount
The SOLID Diff cover has the PROPER amount of fluid in it now. I bought a small hand pump and it was taking FOREVER. So I just took the cover off and started over. Had it fixed in less than 2 hours (1 hour of that was waiting on the rtv sealant to set up).
I recommend this cover to any one out there. It was my fault that I put too much fluid in there. I filled it up to where I could just touch the oil with my pinky and whatda know? Too much fluid by that point. It came out of the breather tube. Notice the shinyness on the right side of the axle.
***NOTE to everyone. Do NOT put more than the recomended amount of fluid in the rear axle, no matter how high or low the fill plug is. It WILL come out of the breather tube. I'll take this one for the XK/WK team. Peace fool***
SOLD - 2005 | WK | Khaki | 3.7 | QT1 | OME HD Front Struts | Rusty's 2" lift in Rear w/ Monroe load levelers (F150 version) | 265/70 Nitto Terra Grapplers | 17" Moabs | 1.5" wheel spacers | Pinch weld mod | Rear fender trim mod | 4xG Matrix w/ reciever hitch | 4xG Belly guard | SOLID Diff cover | Cobra CB radio | 4xG CB radio antenna mount
The hood goes up on it's own? I think the strut suppose to help you lift the hood then just hold it open. Granted the amount of help it needs could mean it's worn. I forget but should only take like two or three fingers to lift the hood.
Sent from my iPhone using Tapatalk
There are currently 1 users browsing this thread. (0 members and 1 guests)