Tire Gate.

[AJeepZJ]

I would go with a similar concept but use bracketry through the bumper instead of the body around the tail light. It'll probably be difficult to reinforce that area and the hatch.

Conceptually, envision the tiregate design supported by brackets directly on the bumper as opposed to the hitch... which gives me another idea, shackle mounts through the bumper anyone???

I'm having a hard time envisioning that. What support is there in the bumper... are you talking about the 'shoulders' on the edges? I would think it would be very easy to reinforce the mounting points from the inside using thicker steel brackets.

I've mentioned it a couple times. I want 4xG rear sliders with attached swing out carrier.

I would not be opposed to this at all....