My front bumper fit really well. The rear was a bit tight, so I took a bottle jack and a 2x4 and spread it out a bit. The rear takes a few more skills. There are 4 side mounts that two small brackets get bolted on and then you have to cut a 3/4" pipe type bracket that they send to fit and then tack weld them. Then I took the bumper off and welded them all up good. Then put the bumper back in place and bolted it up.
As I said before I did modify the rear more to my liking I cut almost 3" off across the bottom up to the bottom of the shackle mounts. I did this with the plasma cutter and cut the sides to taper down.
I will post some pics on it in a few days. As soon as I wash all the mud out.
Reply With Quote