I think I have come up with a way to eliminate the Low Lock error code completely. It would require another wheel sensor and 4 relays. Spot welding equally spaced targets on the rear driveshaft flange up by the transfercase, and mount the wheel speed sensor to the transfercase to read these targets. Then when in Low or Low Lock switch on the relays with my program to read this wheel sensor, instead of the actual wheel sensors.
Last edited by cmdr jim; 05-21-2012 at 12:55 PM.
06 Red Jeep XK 3.7L V6 QT1, RC 2" with 1/2", 1-1/4" Wheel Spacers, Rubicon Moab Rims, Grabber AT2 LT265/70-17, Rocky Road Supersliders, Fastman Throttle-body, K&N Cold Air Filter, JBA Headers, Front Tow Hooks, 2" receiver front & rear, Wired for winch front & rear, ARB Onboard Air, Trans Temp Gauge, Aux Trans Cooler, Sport Roof Crossbars, Skid Plates, RS5010 Rear Shocks, JKS 2034 Front & 2001 Rear Disconnects
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote