Here is the modified wiring, Pins 1, 2 & 3 cut and wired to run to my controller. Please note I have soldered and heat-shrink-ed all connections and sealed of cut ends of wiring harness that will not be used. I have run these wires along the stock wiring harness using tie-wraps. All changes under the console are complete.
Next will be making up the panel to mount the two modules and relays that will power and control the Transfercase Motor, that will be going in under the passenger side rear seat.
After that running the wires between the two areas, adding the key switch and testing the Transfercase before actually installing it. One step at a time.