Sorry, phone hadn't updated, what Matt and Sal said!! :-D
Sent from my LT18i using Tapatalk 2
Sorry, phone hadn't updated, what Matt and Sal said!! :-D
Sent from my LT18i using Tapatalk 2
2007 WH Grand Cherokee CRD QDII - 3" Exhaust, GDE Flash Tune, CRDSTU Hybrid Lift & bash Plates, 4xGuard Rock Rails & Rear Sliders, Saguaro F&R Bars, Warn 9.5CTI-s, AEV Saverge Rims, 35" KM2's, Snorkel, Custom Rear Drawers, ARB Dual Compressor + On Board Air, BullyDog Monitor, Dual Optimas Front and Dual Rear Aux Batteries YouTube Vids
I have the pivot points all worked out as to keeping it all as stock, think of it as moving everything down 1-1/2". So when done the CV joints and tie rods see a 2-1/2" lift, Is 2-1/2" of lift too much?
06 Red Jeep XK 3.7L V6 QT1, RC 2" with 1/2", 1-1/4" Wheel Spacers, Rubicon Moab Rims, Grabber AT2 LT265/70-17, Rocky Road Supersliders, Fastman Throttle-body, K&N Cold Air Filter, JBA Headers, Front Tow Hooks, 2" receiver front & rear, Wired for winch front & rear, ARB Onboard Air, Trans Temp Gauge, Aux Trans Cooler, Sport Roof Crossbars, Skid Plates, RS5010 Rear Shocks, JKS 2034 Front & 2001 Rear Disconnects
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote