Had to bring the little guy inside for a break and some juice... so figured I'd post some pics of what i've done so far.
I traced the outline, cut it out, and now I have it clamped in place. Next step is to try melting/bending the edges to conform to the rack.... then drill some hols and it should be done. Might throw some 3M around it too so it's really held in place.
Nice
PJMJR508
(Happy Jeep)
Heating/bending
And a plastic rivet on each side just to keep it a little extra secure so the ends don't try to "pop" up over time, especially during the summer when the 3M tape will get really hot.
Nice!
Sent from my DROID RAZR using Tapatalk 2
Nice I will take one as well lol
PJMJR508
(Happy Jeep)
lol. bending that lower edge was a PITA.
Looking forward to seeing if/how it affected wind noise from the rack.
I bet
PJMJR508
(Happy Jeep)
Nice job on the deflector Matt! nice touch using Jeep plastic rivets too
2007 WH Grand Cherokee CRD QDII - 3" Exhaust, GDE Flash Tune, CRDSTU Hybrid Lift & bash Plates, 4xGuard Rock Rails & Rear Sliders, Saguaro F&R Bars, Warn 9.5CTI-s, AEV Saverge Rims, 35" KM2's, Snorkel, Custom Rear Drawers, ARB Dual Compressor + On Board Air, BullyDog Monitor, Dual Optimas Front and Dual Rear Aux Batteries YouTube Vids
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
