I just talked to Bob and he said it wouldnt be worth making these to sell. I wasnt aware of this, but he said about 5 hours of machining went in to making the set of links. I guess they used special sleeving that was really expensive and by the time all is said and done he would have to sell them for an arm and leg to make any kind of profit. Espically because you have to start out with a new oem link. However, if anyone is interested, fixed length extended oem links would be a lot easier to make and wouldnt cost much to do so. They obviously just wouldnt be adjustable but they could be built specifically for those running spacer lifts or the OME setup.