06 4.7 | Modded 6" Lift | JBA 6" Coils | Rustys Rear UCA's | Fox Shocks | JBA UCA's | Gibson Catback w/ FM S44 Muffler | K&N CAI | Hypertech | 4.56 Gears | Powertrax Locker | Autolite Iridiums | Mobil 1 (engine&diff) | 34" BFG AT's | 20x9 Ultra Gauntlet | EBC Dimpled&Slotted Rotors | Hawk Ceramic Pads | Blue Interior LED's | Husky Floor Liners | VVME 8000k HID | Pioneer AVH-P8400BH | Tinted LED Tail Lights
I know everyone advises against it.. but i have decided to double stack my RC 2" lift on top of the OME HD 2" lift. I bought the shocks and rear coils thinking I was just going to run them and Matt's rear spacer, but in the middle of the install I ultimately decided in double stacking. I bought a set of used front OME springs from a member and just waiting on the arrival of the OME struts. These pics are current pics of my jeep with my new rims and TEMPORARY 275/60r20 Goodyears. Also it is double stacked in the rear with just the RC lift and a 3/8" spacer in the front!
06 4.7 | Modded 6" Lift | JBA 6" Coils | Rustys Rear UCA's | Fox Shocks | JBA UCA's | Gibson Catback w/ FM S44 Muffler | K&N CAI | Hypertech | 4.56 Gears | Powertrax Locker | Autolite Iridiums | Mobil 1 (engine&diff) | 34" BFG AT's | 20x9 Ultra Gauntlet | EBC Dimpled&Slotted Rotors | Hawk Ceramic Pads | Blue Interior LED's | Husky Floor Liners | VVME 8000k HID | Pioneer AVH-P8400BH | Tinted LED Tail Lights
You sure that rotor's on the correct side?
Edit: you should leave it like that... or do the OME + spacer in front (like im running). The stance will be about the same and work out OK. Those tires look small for a 33 though... are they bald?
Last edited by Matt; 04-14-2013 at 06:17 PM.
The boxes were labeled front left, rear right etc. so I am hoping they are on the right side! This is the passenger side front. I am going to double stack though and run JBA's new UCA's and if it doesnt work ill do what your running. But the tires have about 35% tread left on them. They are bigger than the 285/70/17 nittos that I had.
06 4.7 | Modded 6" Lift | JBA 6" Coils | Rustys Rear UCA's | Fox Shocks | JBA UCA's | Gibson Catback w/ FM S44 Muffler | K&N CAI | Hypertech | 4.56 Gears | Powertrax Locker | Autolite Iridiums | Mobil 1 (engine&diff) | 34" BFG AT's | 20x9 Ultra Gauntlet | EBC Dimpled&Slotted Rotors | Hawk Ceramic Pads | Blue Interior LED's | Husky Floor Liners | VVME 8000k HID | Pioneer AVH-P8400BH | Tinted LED Tail Lights
I dont think those tires look small but if I recall correctly Kyle said they were used. I think his jeep sits a good inch or do higher than mine now
Last edited by 07JeepXK; 04-14-2013 at 06:35 PM.
2007 4.7 Liter XK | Front Modified OME HD Lift | Rear 4" Superlift | JBA UCA's | Rusty's Rear Adjustable Track Bar | Rysty’s Adjustable Upper and Lower Rear Control Arms w/Heim Joints | Mickey Thompson Classic III 17x9 Wheels | 315/70R17 Goodyear Duratracs | Airflow Snorkel | Flowmaster 40 Series Muffler | Superchips Flashpaq | Mopar Skids | 4xGuard Belly Guard | American Rebel Rear Diff Cover | Rear Powertrax No-Slip | Front Electronic Locker | Rear Heat/AC Delete
I'm a bit confused on your current setup...did you say you just installed the OME rear coils and kept your RC lift in there also for now? If so, it looks like you might have put the coils on the wrong side. One side is slightly longer to compensate for the gas tank. Looks good otherwise! I would also advise against stacking your RC lift and OME coils in the front. I would just do the OME coils with 1/2 inch spacer in the front.
John
2007 Grand Cherokee Limited | QDII | 3.0L Diesel | S4xC Shackles Mounts | Goodyear Duratracs
Bilstein HD Front/Rear | Rusty's 1/2" Strut Spacer | Hemi XK Front/Rear Coils | HID Projectors
06 4.7 | Modded 6" Lift | JBA 6" Coils | Rustys Rear UCA's | Fox Shocks | JBA UCA's | Gibson Catback w/ FM S44 Muffler | K&N CAI | Hypertech | 4.56 Gears | Powertrax Locker | Autolite Iridiums | Mobil 1 (engine&diff) | 34" BFG AT's | 20x9 Ultra Gauntlet | EBC Dimpled&Slotted Rotors | Hawk Ceramic Pads | Blue Interior LED's | Husky Floor Liners | VVME 8000k HID | Pioneer AVH-P8400BH | Tinted LED Tail Lights
I fixed everything by removing the 1/4" spacer, cutting a coil of the HD spring, and reseating the spring. This is how she is now! 39.25 to front fender, 38.5 in the back with 20% 275/60/20
Also keep in mind these pics are from as soon as the tires were mounted and they were on the ground. The distance between the spindle and spring has increased now and I still have to get it aligned.
06 4.7 | Modded 6" Lift | JBA 6" Coils | Rustys Rear UCA's | Fox Shocks | JBA UCA's | Gibson Catback w/ FM S44 Muffler | K&N CAI | Hypertech | 4.56 Gears | Powertrax Locker | Autolite Iridiums | Mobil 1 (engine&diff) | 34" BFG AT's | 20x9 Ultra Gauntlet | EBC Dimpled&Slotted Rotors | Hawk Ceramic Pads | Blue Interior LED's | Husky Floor Liners | VVME 8000k HID | Pioneer AVH-P8400BH | Tinted LED Tail Lights
Looks good man! Didnt respond to your texts I was driving went to pick a new project car.. Results look good keep updated on how the stacking lift goes..
2K6 Limited Jeep Green Metallic/Saddle Brown Leather XK HEMI QDII Old Man Emu HD Suspension w/ Fox Emulsion 2.0 Rear Shocks 1.5" SpiderTraxx Wheel Spacers 265/70 GoodYear MTRs w/Kevlar True Dual Exhuast w/IMCO 50 K&N 63 CAI Diablo 91/Performance Transmission Tuned SA Belly Skid MOPAR Gas Tank Skid, Transfer Case Skid, Suspension Skid Front Tow Hooks 6k HID Lows/3k Fogs
2007 Commander Overland / 4" SuperLift / 285/70R17 Cooper Discoverer ST Maxx / Rusty's adjustable rear UCAs / Carolina Driveline front drive shaft / Flashpaq / DRLs & Tilting Mirrors / Autolite Iridiums / Cobra 29LX Chrome LE CB & Firestik antenna / Rear fog lights / Mopar Grille Guard with HID driving lights
"4 wheel drive does not mean 4 wheel stop!" -Lee Goldberg, WABC TV weatherman
There are currently 1 users browsing this thread. (0 members and 1 guests)