Yes, in that photo the grill had not been attached and the bumper was too tight. We had to remove the bottom three bolts from the bumper to release the pressure and it fit.
Yes, in that photo the grill had not been attached and the bumper was too tight. We had to remove the bottom three bolts from the bumper to release the pressure and it fit.
2006 XK Limited, 5.7L Hemi
Dark Khaki, QDII, Rocky Road 2.25" lift, Steel Armadillo front bumper with Warn PowerPlant winch, Steel Armadillo rear bumper w/ tire carrier, Rock Sliders, Light Bar & Front Fender Tube Fenders, 4xGuard belly skid plate & rear differential guard, BFG M/T A/T 255/75R17s on Rubicon rims, Spidertrax 1.5 inch wheel spacers, Rhino Rack Pioneer Tray with FoxWing Awning, Superchips VIVID Programmer, Air Flow snorkel, Steel Armadillo Secure Console, Cobra CB Radio, Lock Pick Video Programmer, ASFIR Skid Plates.
Knappster's Garage
AKA: the Owner of The Steel Armadillo L.L.C.
Thanks !!
Anybody got pointers on drilling out the spot welds ? Really struggeling with them. Need the crossmember off so I can start mounting the hiddden winch
Slightly bigger bit then whatever your trying to drill out. I thought people were cutting the cross member out?
Drilling is much cleaner but it does take some work as you have to step up the drill bits unless you have one of the ones with many different sizes all-in-one.
2006 XK Limited, 5.7L Hemi
Dark Khaki, QDII, Rocky Road 2.25" lift, Steel Armadillo front bumper with Warn PowerPlant winch, Steel Armadillo rear bumper w/ tire carrier, Rock Sliders, Light Bar & Front Fender Tube Fenders, 4xGuard belly skid plate & rear differential guard, BFG M/T A/T 255/75R17s on Rubicon rims, Spidertrax 1.5 inch wheel spacers, Rhino Rack Pioneer Tray with FoxWing Awning, Superchips VIVID Programmer, Air Flow snorkel, Steel Armadillo Secure Console, Cobra CB Radio, Lock Pick Video Programmer, ASFIR Skid Plates.
Knappster's Garage
AKA: the Owner of The Steel Armadillo L.L.C.
They were a bit pita did you reuse the holes on the bottom or drill new ones ?
There are currently 1 users browsing this thread. (0 members and 1 guests)