Convert swing down to swing out

[hoaxci5]

Well I started the conversion today, and killed my 10 year old angle grinder.. So I picked up a new Porter Cable one, and will be back to work on it tomorrow, and hopefully have it mostly finished up.

[Matt]

Making quick work of that man!

[hoaxci5]

"finished" it today, I put that in quotes because I'd still like to figure out a way to mount my hi-lift back there, and maybe relocate the license plate. But overall it's functional, it's not pretty, but it works...









Here is where I ran into a problem, I didn't weld the hinge with this pin in place.. the hinge setup was a pain in the a$$ so I had to improvise.


Mission accomplished.. good thing it's an old xj, everything looks a little rough on this thing so those welds aren't out of place :P


Nice plate gusset..






Overall I'm into it for $30 maybe? plus replacing my 10 year old angle grinder at $40 but that thing was a used and abused ryobi so I can't complain. Hopefully my "hinge" holds up, it's got some droop when open but so far so good..

[Matt]

Came out pretty good man. Since the tire was on such an angle from the start, that little "oops" didn't really hurt the overall outcome.

Is that an 18v dewalt grinder i see there?????

[hoaxci5]

Yea it works great for cleaning up with a wire brush, but cutting it's useless, but you already know that don't you?

[Matt]