I installed the JKS 2034 in the front of my XK this weekend.
They are a tight fit with the spindle, but do fit and I have had no rubbing, clunking, or rattling with then yet (about 50 miles).
You do have to turn the wheel Left to install and remove left side and same for right side.
The 2034 are made for the Wrangler and have a short pin on the top right. I was going to separately purchase a standard tapered pin, but glad I did not, as the XK requires the short pin on the upper right as well.
Again, these are a tight fit with the spindle at the top end (I have mine set about 1" - 1 3/8" longer than stock to compensate for the lift, but any more than that and you won't have room to get them on/off and clear when turning).
Reply With Quote