ok this sounded easy enough but im stumped. a year and a half ago when I put the lift on the front I got a bit close to the CV joint boot with a torch. needless to say it has finely given up the ghost and is howeling pretty good. so I got together a new drivers side shaft and a new wheel bearing and set out 2 nights ago to replace the said shaft.
well so far I have everything off and out with the exception of the inner joint cup. I can not get it out of the dif to save my life. am I missing something? is there a C clip on the inside? so far I have tried prying from the back of the cup, crow bars and hammers, pickle forks and the last straw was tonight I borrowed a large slide hammer from Tymac but still have not gotten it to budge. the jeep is an 06 limited with the 4.7 engine.