yours is really stuck, let us know what the shop says.
yours is really stuck, let us know what the shop says.
PJMJR508
(Happy Jeep)
it will be going over today. to make matters worse as I was working on it I shifted the t-case into neutral thinking it would be easier to turn the shaft as I tried to remove it. now it wont shift back into gear, it just tells me 4wd needs service (no****)
thank god I have AAA
2007 4.7 Liter XK | Front Modified OME HD Lift | Rear 4" Superlift | JBA UCA's | Rusty's Rear Adjustable Track Bar | Rysty’s Adjustable Upper and Lower Rear Control Arms w/Heim Joints | Mickey Thompson Classic III 17x9 Wheels | 315/70R17 Goodyear Duratracs | Airflow Snorkel | Flowmaster 40 Series Muffler | Superchips Flashpaq | Mopar Skids | 4xGuard Belly Guard | American Rebel Rear Diff Cover | Rear Powertrax No-Slip | Front Electronic Locker | Rear Heat/AC Delete
I had put the t-case in neutral. it seems that once it did not register the half shaft it would not let it re-engage.
anyhow got everything up and running again. the guy at the shop just had a bigger slide hammer than me. he used a die grinder and a cut off disc to cut a hole in the stub shaft so he could get the hook of his "frame starighening" slide hammer hooked on the inside getting a more direct straight pull on the shaft. the next thing was to hook 2 bungee cords to the shaft. this he told me was to keep tension on the stub shaft so after he hit it it would kind of set up a rocking motion until the ring clip finally collapsed and come out. he did say it took about 5 minutes of hammering before it came out. once the shaft was reinstalled the t-case connected up with no problem.
glad to hear it worked out.
PJMJR508
(Happy Jeep)
There are currently 1 users browsing this thread. (0 members and 1 guests)