Jon is checking with SL to see if the items that did not arrive in the lift is needed or not. If not I will be getting all of it installed this coming weekend.

Before I do this I want to run the setup past you just to make sure nothing was missed or had the wrong impression on what need to be done.
Front:
SL Kit (full Kit)
Using OME HD front springs with 1 coil cut off
5100 Adjustable Struts set to .75
Rustys 1/2" Strut spacer (already have it on the XK for the OME HD setup)
JBA UCA's (latest GEN) (already have it on the XK for the OME HD setup)
RCV Axles
New LCA's

Rear:
JBA 6" coils
Fox 12" remote res shock (7/8's shaft)
2 sets of Matt's 1/2 coil spacers, 1 " per side. I will only use these if needed to make level.

Set of 315's rubber all the way around.

Question I have for the front, do I still use the SL Strut 4" spacer even tho I am using the OME HD springs? I thought I read on here that it will be to high if I use the SL 4" spacer.

If I do use the SL strut 4" spacer, other than the shocks & springs I am replacing with the Fox & JBa's one I got. I am to use the entire kit right?
I want to make sure all is right before dropping it off.
Thx for the input all.


I know I will need to replace the Front & rear DS & also the rear UCA & rear LCA too, those will be done one at a time & with in the next 6 months