I started with a 20' long pair of jumper cables (2 gauge stranded wire if I recall). Cut off a bout 3 feet and wired to the battery and down to the front mount where I attached a quick disconnect. Warn makes them but they are expensive, you can save a lot of money with a generic pair (MileMaker?). I have both and quality is the same. Then I attached the matching quick disconnect to the wires that came with the winch.
I have always intended on routing the rest of the wire along the frame rail and attaching a quick disconnect at either end for the rear but haven't got that far yet. I must have been planning on the write-up once that was complete, but this will havae to suffice for now.
2010 5.7 QTII - OME HD w/ 3/8" spacers up front and F150 MLL in rear, JBA UCA 6.7, JKS 2034 Front Quick Disconnects, Gas Tank Skid Mod, PinchWeld Mod, 1.5" SpiderTrax, General Grabber AT 265/70/17, Custom Front Receiver / Plow Mount, Custom Tow Rings F/R, Diablo Intune.
There are currently 1 users browsing this thread. (0 members and 1 guests)