How do you apply these decals? I assume they go on the outside of the glass but are they true decals which you apply wet, or are they stickers that you apply dry?
How do you apply these decals? I assume they go on the outside of the glass but are they true decals which you apply wet, or are they stickers that you apply dry?
'06 XK Limited, 5.7 Hemi, QDII, OME struts & HD springs, JBA UCAs, 285/70R17 BFG KM2, 4XGuard Sliders, 4XGuard Diff Guard, Fox 2.0 reservoir shocks, custom bumpers and Warn xi9000
Wish list: SFA, in-dash Windows 8 PC
2006 XK Limited, 5.7L Hemi
Dark Khaki, QDII, Rocky Road 2.25" lift, Steel Armadillo front bumper with Warn PowerPlant winch, Steel Armadillo rear bumper w/ tire carrier, Rock Sliders, Light Bar & Front Fender Tube Fenders, 4xGuard belly skid plate & rear differential guard, BFG M/T A/T 255/75R17s on Rubicon rims, Spidertrax 1.5 inch wheel spacers, Rhino Rack Pioneer Tray with FoxWing Awning, Superchips VIVID Programmer, Air Flow snorkel, Steel Armadillo Secure Console, Cobra CB Radio, Lock Pick Video Programmer, ASFIR Skid Plates.
Knappster's Garage
AKA: the Owner of The Steel Armadillo L.L.C.
I always apply them wet.. i use a water/soap solution (very very very little soap) so that I can move the decal around a little to make sure its positioned perfectly. Then you squidgy out the water and air bubbles and let it sit for an hour or so to dry (or use a hair dryer).
Ok. Now I'm really confused.
'06 XK Limited, 5.7 Hemi, QDII, OME struts & HD springs, JBA UCAs, 285/70R17 BFG KM2, 4XGuard Sliders, 4XGuard Diff Guard, Fox 2.0 reservoir shocks, custom bumpers and Warn xi9000
Wish list: SFA, in-dash Windows 8 PC
They're stickers that you can apply dry, but then there's no room for error. So i use the water/soap solution to get the position perfect.
I rub an ice cube on them, it helps seperate the backing, and there was a little room for error.
2007 Jeep Commander: QTII, Leather, Sunroof, remote start, OEM Skid Plates, 2 in Daystar lift, 255.75.17 BFG Mud Terrains on Moabs, 1.25 " Spidertrax wheel spacers, 4x Guard front guard and Side Guards, Optima Red Top, Robbys half inch leveling spacer, Bilstein 5150 Rear Shocks, Pinch weld mod and trimming!
i just stick em and forget em. they are small enough that you can position them easily and small enough that you wont get air bubbles. i would use a water / soap solution on a large decal but didnt seed the necessity on these but you can if you like, its really no big deal.
'07 Commander 3.7 V6
2" Rough Country Lift with Vision Warriors and Goodyear Duratracs 245/75R17
BajaRack Mega-Mule with KC Daylighters
http://s624.photobucket.com/albums/t...cpZZ1QQtppZZ20
There are currently 1 users browsing this thread. (0 members and 1 guests)