i put a couple switches in that little cubby hole on the left.
i put a couple switches in that little cubby hole on the left.
Have you tried that lower middle fuse I suggested? I think that's the best one because it'll shut off your lights when you turn off the ignition. Unless you want them on even with the XK is not running then I would suggest looking for a constant power line.
- Oscar aka LuvMyCommander
2008 Commander 3.7L V6
Mods: OEM tow hitch, OEM 7 pin tow wiring, OEM fog lights, daytime running lamps enabled, 4xGuard Matrix Guard w/grill hoop kit, RC 2" lift kit, K&N drop-in filter, PIAA 510 ATP aux lights
Posted this in the Matrix Pushbar thread as well but again I'd use the switch as a ground activation vice a 12V activation for the relay. Much easier to do and no splicing required. Splice the 2 hots on the relay together to save on running another wire (stuff 2 wires pigtailed together into a crimp connector to make the jumper). Good luck on the install.
Old: 2006 Base, 4.7L, QT-II
New: 2010 Sport, 5.7L, QT-II, Front Tow Hooks, Tow Package and 7 pin Mopar Harness ( Spliced 4 pin into harness), Mopar Skid Plates
06 Hemi Limited,black,QD2,elsd,loaded minus back up camera,OEM hitch with 7pin harness. RC 2"lift,BFG Rugged Terrains 265x70x17(31.7"),1 3/4" Rugged ridge wheel spacers(front), 4xguard Matrix Pushbar and Grill Hoop,4xguard rockrail/sliders,4xGuard 12 bolt diff guard,6"Hella 500 Black Magic Driving lights.
Thanks everyone for your input ! I ended up finding a fuse in the interior fusebox thats off with the ignition. I used a "add a fuse" from autozone and tapped into it. Worked great !
The lights were working great until the light in the switch stopped working,so I figured I would take it apart see if I could change out the bulb,then the whole switch fell apart !!
Back to autozone for a new one tomorrow !!
06 Hemi Limited,black,QD2,elsd,loaded minus back up camera,OEM hitch with 7pin harness. RC 2"lift,BFG Rugged Terrains 265x70x17(31.7"),1 3/4" Rugged ridge wheel spacers(front), 4xguard Matrix Pushbar and Grill Hoop,4xguard rockrail/sliders,4xGuard 12 bolt diff guard,6"Hella 500 Black Magic Driving lights.
06 Hemi Limited,black,QD2,elsd,loaded minus back up camera,OEM hitch with 7pin harness. RC 2"lift,BFG Rugged Terrains 265x70x17(31.7"),1 3/4" Rugged ridge wheel spacers(front), 4xguard Matrix Pushbar and Grill Hoop,4xguard rockrail/sliders,4xGuard 12 bolt diff guard,6"Hella 500 Black Magic Driving lights.
In my KJ I had the green wire going to something switched ignition on. Radio, I think. Just get one of those add-a-fuse things from AutoZone and you don't have to splice.
This is with all of my lights on, including MOPAR Lightbar.
Same picture with a much faster shutter speed.
There are currently 1 users browsing this thread. (0 members and 1 guests)