How to set the combination:

1) The combination is factory set at >>0-0-0<<
2) Combination must be on opening number prior to resetting.
3) On the underside outer edge of the lock there is a hole for
the code reset button. Rotate the face of cam until the code
reset button comes into view.
4) Push this pin in with a paper clip and keep it pushed in.
5) Set your personal combination by turning the dials to the
desired combination.
6) Release the reset button and your new combination is set.
7) To lock, rotate lock to “Locked” position. Rotate one or more
dials after lock is closed. To open the lock, turn dials to
your personal combination.
NOTE: If you desire, The Easy Access Combination Lock can
be installed such that it is non resettable by the end user.
*Take off the screw to the cam and remove the cam and the
stop cam.
Rotate the cylinder 180 degrees and then put the Stop Cam
and the cam back on.