The installed unit has a clean professional, high quality look to it which is what you expect when you are installing it in a $40,000 vehicle.





So, How easy is it to install?

The only tools you need are a simple adhesive, I used Loctite but a silicone sealer will work just as well if not better.



The adhesive is placed on the top edge of the center console nearest the passenger seat, three screws hold the drivers side in place but there was no way to attach the passenger side without modifying your console. The adhesive is NOT required and this is what you would skip if you think you might take the "Secure Console" out later.

The three screws are tighten by hand but you can tighten them with a small wrench if you want to.

Once the adhesive is applied if you are using it then you can install the "Secure Console" itself.



Line the unit up with the front edge of your console



Drop the tab in under the front edge



And let the back end drop into place.

If you used a adhesive/sealant then follow those instruction as to applying pressure or resting time before continuing with these instructions.

When you are ready to continue with the install open the lid.



Line up the support brace, it can only go in one direction.



Slide the brace over the three small bolts.



And start to attach the three nuts.