I had to have 4wheel parts do my front.
I had to have 4wheel parts do my front.
PJMJR508
(Happy Jeep)
lookin good and the same colour as mine! I keep trying to buff the scratches out but they seem to be a bit far gone
'07, 4.7L, QTII, 2" lift, T-boddy spacer, flowmaster 40, HID's, CB, JVC nav/DVD, 245/75/17 Wrangler Territory's, Superchips, 6' roofrack with 8 lights, LTD grab handles, rear storage compartment, chassis rock lights, clinometer, yadda, yadda, yadda
Nice, I never see my color Jeep. I will go through your pics now
2007 Jeep Commander: QTII, Leather, Sunroof, remote start, OEM Skid Plates, 2 in Daystar lift, 255.75.17 BFG Mud Terrains on Moabs, 1.25 " Spidertrax wheel spacers, 4x Guard front guard and Side Guards, Optima Red Top, Robbys half inch leveling spacer, Bilstein 5150 Rear Shocks, Pinch weld mod and trimming!
Spent about an hour today with the angle grinder and got one of the side guards down to bare metal. Lots of freaking work, but the result is making me very happy. I have not decided what I am going to paint them with, so if you have any suggestions, speak up please. (Fiance asked if they had chrome paint...)
2007 Jeep Commander: QTII, Leather, Sunroof, remote start, OEM Skid Plates, 2 in Daystar lift, 255.75.17 BFG Mud Terrains on Moabs, 1.25 " Spidertrax wheel spacers, 4x Guard front guard and Side Guards, Optima Red Top, Robbys half inch leveling spacer, Bilstein 5150 Rear Shocks, Pinch weld mod and trimming!
Progress so far. I am doing 4 coats of Primer with Rust stop, and bed liner for the inside. For any of the guys that are running these, do you have the specs for the hardware needed for install. I have sent Marvin a handfull of Emails trying to get what I need, but I will just buy my own and use Grade 8 Hardware.
Thanks
2007 Jeep Commander: QTII, Leather, Sunroof, remote start, OEM Skid Plates, 2 in Daystar lift, 255.75.17 BFG Mud Terrains on Moabs, 1.25 " Spidertrax wheel spacers, 4x Guard front guard and Side Guards, Optima Red Top, Robbys half inch leveling spacer, Bilstein 5150 Rear Shocks, Pinch weld mod and trimming!
You can download the installation instructions from the 4xg website.... it has a parts list on the first page.
Just curious. Did you use an actual angle grinder wheel or the steel wool pads? If you had the steel wool pads i think there wouldn't be any rust left on these whatsoever after about 20 mins.
2007 Commander 4.7L, QTII, OEM Towing Option, tow hooks, 2"OME + 1/4" rusty's leveling spacer, Bilstein 5150 Rear Shks, Rear sway bar removed, 4xguard front skid, Offroad Unlimited Defender Roof Rack, Hella 500FF lights, 265/70/R17 BFG KM2 M/Ts 1.5" Rough Country Wheel Spacers
http://www.theultimatejeep.com/showt...acerc-s-Garage
There are currently 1 users browsing this thread. (0 members and 1 guests)