Added the lights:
And some factory quality wiring (i used weatherproof disconnects for all of the lights and also the loom-to-car connection... so everything can be quick disconnected for service)
I just need to get some relays (they were sold out!!!) and a 15/16th drill bit for my switches tomorrow and im set
Last edited by Matt; 10-17-2011 at 04:26 PM.
That's some serious lighting man. Looks pretty cool to
Thanks man. going to finish wiring the switches after i have my coffee this morning. I think im doing some flush mount button switches under the left side cubby hole (where i'll eventually put a CB).
Which reminds me.... im probably going to use one of the Matrix light tabs for a CB antenna mount
Ok.... all done with the wiring.
I ran the wiring through the firewall using an existing grommet:
I'm a nut with my wiring harnesses... if it doesn't look factory installed, i didnt do my job right!
Ran around the fender to the battery:
Last edited by Matt; 10-17-2011 at 04:27 PM.
My secondary Harness for the quick disconnect:
Last edited by Matt; 10-17-2011 at 04:28 PM.
....................maybe this should be moved to a "how to" section lol
I did move it to "exterior modifications".Originally Posted by Matt_
2006 XK Limited, 5.7L Hemi
Dark Khaki, QDII, Rocky Road 2.25" lift, Steel Armadillo front bumper with Warn PowerPlant winch, Steel Armadillo rear bumper w/ tire carrier, Rock Sliders, Light Bar & Front Fender Tube Fenders, 4xGuard belly skid plate & rear differential guard, BFG M/T A/T 255/75R17s on Rubicon rims, Spidertrax 1.5 inch wheel spacers, Rhino Rack Pioneer Tray with FoxWing Awning, Superchips VIVID Programmer, Air Flow snorkel, Steel Armadillo Secure Console, Cobra CB Radio, Lock Pick Video Programmer, ASFIR Skid Plates.
Knappster's Garage
AKA: the Owner of The Steel Armadillo L.L.C.
Some finished shots of the wiring....
One thing I mis-judged was how far away the rad hose was... I like having plenty of distance there, but should be good.
And some more of the light bar itself:
Last edited by Matt; 10-17-2011 at 04:29 PM.
Ok, now for work on the interior...
Where it comes through the dash:
Template for my switches:
Bet you cant find my wires.....
Last edited by Matt; 10-17-2011 at 04:30 PM.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
