Got to work on the TJ some tonight. I been sick all week and haven't done much but cleaned up the garage.
Tonight I pulled the exhaust manifolds and installed new brass freeze plugs. As I was putting them in I realized that kit didn't have enough plugs. I need 2 more plugs. Anyway, I put in what I had and I'll call him tomorrow to tell him.
After that, I pulled the valve cover off to install the new valve cover gasket. I inspected the valve train while I was there. All was good, a couple of push rods were a little tight, no broken springs or loose rockers. Very good. Then I cleaned the valve cover and head and installed the new valve cover gasket.
Reply With Quote